Pixsys ATR144 - Page 48

48 - ATR144 - User manual
7 i.o.L.1 Linear Input over Limits AI1
If AI1 is a linear input, allows the process to bypass the
limits (Par. 4 and 5).
diS a b. Disabled (Default)
En a b. Enabled
8 o . c A .1 Offset Calibration AI1
AI1 Offset calibration. Value added/subtracted to
the process value (ex: usually correcting the ambient
temperature value).
-9999..+9999 [digit
1 p. 86
] ( degrees.tenths for
temperature sensors ). Default 0.
9 G . c a .1 Gain Calibration AI1
Value multiplied to the process value to calibrate the
working point. Ex: to correct the range from 0..1000°C
showing 0..1010°C, set the parameter to -1.0
-100.0%..+100.0%, Default: 0.0.
10 L t c .1 Latch-On AI1
Automatic setting of limits for AI1 linear input.
diS a b. Disabled. (Default)
Stnrd Standard
v. 0 . s t o . Virtual Zero Stored
v. 0 . t. o n . Virtual Zero at start
11 c . F L .1 Conversion Filter AI1
ADC Filter: Number of sensor readings to calculate
mean that defines process value. NB: when readings
increase, control loop speed slows down.
1..15. (Default: 10)