Pixsys ATR144 - GROUP F - d. 1. 1 - Digital input 1

64 - ATR144 - User manual
12.f GROUP F -
d .i . 1
- Digital input 1
94 d.i.1.f. Digital Input 1 Function
Digital input 1 functioning.
diS a b. Disabled (Default)
2t. s w. 2 Setpoints Switch
2 t.s w.i. 2 Setpoints Switch Impulsive
3 t.s w.i. 3 Setpoints Switch Impulsive
4 t.s w .i. 4 Setpoints Switch Impulsive
st./st. Start / Stop. Status of the controller, upon
power-up, depends on parameter 30 i ni . s .
rUn Run. With the controller in STOP
the alarms remain active.
ext.a l. External alarm. The controller goes on
STOP and the alarms will be disabled.
The controller does not return to START
automatically: for this operation, the
user’s intervention is required.
HoLd Lock conversion (stop all conversions
and display values)
tune Enable / disable tuning if the
parameter 36 t u n .1 is set on manu.
a u. m a .i. Automatic / Manual Impulse (if
enabled on parameter 29 A.MA.1)
au.m a.c. Automatic / Manual Contact (if
enabled on parameter 29 A.MA.1)
a c t.t Y. Action Type. Cooling regulat. if D.I. is
active, otherwise heating reg.
A.i. 0 Analogue Input 0. Set AI to zero
M. reS. Manual reset. Reset the outputs
if selected as manual reset.
t.1. r u n Timer 1 run. The timer 1 runs
while D.I. is activated
t.1. s. E. Timer 1 Start End. D.I. starts and
stops the timer 1(impulsive)
t.1.S t a. Timer 1 Start. D.I. starts the timer 1(impulsive)
t.1. En d Timer 1 End. D.I. stops the timer 1(impulsive)
t.2.ru n Timer 2 run. The timer 2 counts