54 - DRR245 - User manual
15 Configuration EASY-UP
To simplify the setting of parameters and the integration of the different
components involved in the control system, Pixsys introduces the EASY-UP
coding which allows to set sensors and/or command outputs in one single step.
By means of the code listed in the data sheet enclosed to the sensor or actuator
(SSR, motorized valve, etc.) the EASY-UP coding will set the relevant main
parameters on the controllers (ex. selection of PT100 on parameter “Sensor”
and the corresponding measuring range on parameters “Lower and Upper
limits of the setpoint”). Different codes may be entered on the controllers in
sequence to configure inputs, control output or retransmission of signal.
To Next Page
Loading...
