User manual - DRR245 33
12 Table of configuration parameters
The following table includes all parameters. Some of them will not be visible on
the models which are not provided with relevant Hardware data.
1
C.out
Command Output
Command output type selection (see tables).
c. o1
Default (necessary for using process and setpoint retransmis-
sion function with Volt / mA output)
c. o2
Command on relay output Q2
c.SSr
Command in tension for SSR
3
c. u AL.
Servo-valve command with open loop
c.4. 20
4..20 mA command
3
c.0.20
0..20 mA command
3
c.0.10
0..10 V command
3
DRR245-21ABC-T
COMMAND ALARM 1 ALARM 2
c. o1
Q1 Q2 SSR
c. o2
Q2 Q1 SSR
c.SSr
SSR Q1 Q2
c. u AL.
Q1 (open)
Q2 (close)
SSR -
c.4. 20
4..20 mA Q1 Q2
c.0.20
0..20 mA Q1 Q2
c.0.10
0..10 mV Q1 Q2
3
Do not select if process retransmission function is used.
To Next Page
Loading...
