6 - DRR245 - User manual
1 Introduction
Thank you for choosing a Pixsys controller.
Controller DRR245 is specifically conceived for application on control panels
with DIN rail mounting.
Pixsys makes available in a single device all the options relevant to sensor input
and actuators command, in addition to the extended power range 24..230 Vac/
Vdc. With 18 sensors to select and outputs configurable as relay, Ssr command,
4..20 mA and 0..10Volt, the user or retailer can reduce warehouse stock by
rationalising investment and device availability. The series is completed with
models equipped with serial communication RS485 Modbus RTU and with a
loading control function via the amperometric transformer. The configuration
is further simplified by the Memory cards which are equipped with internal
battery and therefore don’t require cabling to power the controller.
2 Safety guide lines
Read carefully the safety guidelines and programming instructions contained in
this manual before using/connecting the device.
Disconnect power supply before proceeding to hardware settings or electrical
wirings.
Only qualified personnel should be allowed to use the device and/or service it
and in accordance to technical data and environmental conditions listed in this
manual.
Do not dispose electric tools together with household waste material. In
observance European Directive 2002/96/EC on waste electrical and electronic
equipment and its implementation in accordance with national law, electric
tools that have reached the end of their life must be collected separately and
returned to an environmentally compatible recycling facility.
To Next Page
Loading...
Need help?
General
