RS232 Codes
Planar RPS and Video Controller RS232 User Guide Page | 32
020-1332-00I
PANEL.VOLTAGE Panel Voltage 1514 ? 1-4294967295 String PANEL.VOLTAGE(8)?
PANEL.VOLTAGE(8):48.12
Returns the input voltage of a panel. No 5.1 Yes Yes
POWER.STATUS External Device
Power Status
2701 ? PS#
PSW#
0=OFF
1=ON
POWER.STATUS(PSW2)?
POWER.STATUS(PSW2):"OFF"
Gets the specified device power state. Yes 8.0
10.0
1
Yes No
PS.PRESENT Power Module
Present
1422 ? 1-4 0=NOT_PRESENT
1=PRESENT
2=INVALID
PS.PRESENT(2)?
PS.PRESENT(2):PRESENT
Returns if a power supply module is
detected within the power supply.
Yes 1. x Yes No
PS.STATUS Power Module
Status
1423 ? 1-4 String PS.STATUS(3)?
PS.STATUS(3):0x284A
This command is used for critical health
status of the RPSM; further diagnosis of an
issue may need to be completed at the
factory.
Output will be in a hexadecimal format.
Converting to binary and noting the
position starting at the right (0 position)
and noting the position of the non-zero
character(s) up to the last (15) will indicate
which faults were seen.
Note: For the example shown, 284A, the
hex value coverts to 0010 1000 0100 1010.
This indicates that 1, 3, 6, 11, and 13 were
noted as fault conditions.
0 = Unspecified fault
1 = Communication Memory Fault
2 = Module temperature may have
exceeded the maximum
3 = VAC is below minimum
4 = IDC is above maximum
5 = VDC is above maximum
6 = Module DC is off
7 = Module is performing previously
requested actions
8 = Unspecified fault
9 = Unspecified fault
10 = Fan failure
11 = Power status
12 = Unspecified Fault
13 = VAC fault warning
14 = IDC fault or warning
15 = VDC fault or warning
0xFFFFFFFF = Module not present, invalid
or off
Yes 1.x Yes No
Command Description
Numeric Command Code
Operators
Modifiers Operands Example Notes
Standalone Component Command
Firmware Version Active
Functional in Fast Start Standby
Functional in Low Power Standby
To Next Page
Loading...
