Planet SGSD-1022 - Mac-Authentication Reauth-Time

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
477
mac-authentication reauth-time
Use this command to set the time period after which a connected MAC address must be re-authenticated. Use the no form of
this command to restore the default value.
Syntax
mac-authentication reauth-time seconds
no mac-authentication reauth-time
seconds -The reauthentication time period.
(Range: 120-1000000 seconds)
Default Setting
1800
Command Mode
Global Configuration
Command Usage
The reauthentication time is a global setting and applies to all ports.
When the reauthentication time expires for a secure MAC address it is reauthenticated with the RADIUS server. During
the reauthentication process traffic through the port remains unaffected.
Example
Console(config)#mac-authentication reauth-time 300
Console(config)#
clear network-access
Use this command to clear entries from the secure MAC addresses table.
Syntax
clear network-access mac-address-table [static | dynamic]
[address mac-address] [interface interface]
static - Specifies static address entries.
dynamic - Specifies dynamic address entries.
mac-address - Specifies a MAC address entry. (Format: xx-xx-xx-xx-xx-xx)
interface - Specifies a port interface.
ethernet unit/port
-unit - This is unit 1.
-port - Port number. (Range: 1-28)