Planet SGSD-1022 - Map Access-List Ip

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
628
Console(config)#map ip tos 0 cos 1
Console(config)#map ip tos
map access-list ip
This command sets the output queue for packets matching an IP ACL rule. Use the no form to remove the CoS queue mapping.
Syntax
[no] map access-list ip acl_name cos cos-queue
acl_name – Name of the IP ACL. (Maximum length: 16 characters)
cos-queue – Port CoS queue. (Range: 0-3)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
You must configure an ACL before you can map a CoS queue to the rule.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#map access-list ip bill cos 0
Console(config-if)#
map access-list mac
This command sets the output queue for packets matching a MAC ACL rule. Use the no form to remove the CoS queue
mapping.
Syntax
[no] map access-list mac acl_name cos cos-queue
acl_name – Name of the MAC ACL. (Maximum length: 16 characters)
cos-queue – Port CoS queue. (Range: 0-3)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)