Planet SGSD-1022 - Show Interfaces Switchport

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
522
show interfaces switchport
This command displays the administrative and operational status of the specified interfaces.
Syntax
show interfaces switchport [interface] interface
• ethernet unit/port
-unit - Stack unit. (Range: 1)
-port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This Example shows the configuration setting for port 2.
Console#show interfaces switchport ethernet 1/2
Information of Eth 1/2
Broadcast Threshold: Enabled, scale:1000K level:5 octets/second
LACP Status: Disabled
Ingress Rate Limit: Disabled, scale:10M level:1
Egress Rate Limit: Disabled, scale:10M level:1
VLAN Membership Mode: Hybrid
Ingress Rule: Enabled
Acceptable Frame Type: All frames
Native VLAN: 1
Priority for Untagged Traffic: 0
GVRP Status: Disabled
Allowed VLAN: 1(u),4093(t),
Forbidden VLAN:
Private-VLAN Mode: NONE
Private-VLAN host-association: NONE
Private-VLAN Mapping: NONE
802.1Q-tunnel Status: Disable