Planet SGSD-1022 - Ip Igmp Snooping Vlan Static

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
642
[no] ip igmp snooping
Default Setting
Enabled
Command Mode
Global Configuration
Example
The following example enables IGMP snooping.
Console(config)#ip igmp snooping
Console(config)#
ip igmp snooping vlan static
This command adds a port to a multicast group. Use the no form to remove the port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
vlan-id -VLAN ID (Range: 1-4094)
ip-address -IP address for multicast group
interface
ethernet unit/port
-unit - Stack unit. (Range: 1)
-port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
Default Setting
None
Command Mode
Global Configuration
Example
The following shows how to statically configure a multicast group on a port:
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet 1/5
Console(config)#
ip igmp snooping version
This command configures the IGMP snooping version. Use the no form to restore the default.
Syntax
ip igmp snooping version {1 | 2 | 3}