Figure 4-36 Ping Watch Dog Utility
¾ Enable - Turn on/off Ping Watch Dog.
¾ IP Address - The IP address of the target host where the Ping Watch Dog Utility is sending
ping packets.
¾ Interval - Time internal between two ping packets which are sent out continuously.
¾ Delay - Time delay before first ping packet is sent out when the device is restarted.
¾ Fail Count - Upper limit of the ping packet the device can drop continuously. If this value is
overrun, the device will restart automatically.
Be sure to click the Submit button to make your settings in operation.
4.7.7 Reboot
Selecting System Tools > Reboot allows you to reboot the AP on the screen shown in Figure
4-37.
Figure 4-37 Reboot the device
Click the Reboot button to reboot the AP.
Some settings of the AP will take effect only after rebooting, which include:
• Change LAN IP Address (System will reboot automatically).
• Change the Wireless configurations.
• Change the Web Management Port.
• Upgrade the firmware of the AP (system will reboot automatically).
• Restore the AP's settings to factory defaults (system will reboot automatically).
• Update the configuration with a file (system will reboot automatically).
54
To Next Page
Loading...
Need help?
General
