User Manual of WNAP-W2201A
-7-
Wireless Management Features
Operation Mode
Standalone AP
Managed AP
Wireless Mode
AP (Multiple-SSIDs)
Client
Repeater (WDS+AP)
Universal Repeater (AP+Client)
WDS PtP Bridge
WDS PtMP Bridge
Encryption Security
WEP (64-/128-bit) encryption security
WPA/WPA2 (TKIP/AES)
WPA-PSK/WPA2-PSK (TKIP/AES)
802.1x RADIUS Authentication
Wireless MAC address filtering (up to 20 entries)
Supports WPS (Wi-Fi Protected Setup)
Wireless Security
SSID broadcast and hide
Supports WMM (Wi-Fi Multimedia) for better data transmission of video or
on-line demand
Supports wireless schedule
Multiple SSIDs: up to 5
Wireless Isolation: Enables it to isolate each connected wireless client of a
BSSID from communicating with each other
IAPP (Inter Access Point Protocol): 802.11f wireless roaming
Wireless Advanced
Provides wireless statistics, max. associated station number
Max. Supported Clients
Wired: 253
2.4GHz Wireless: 32
Built-in DHCP server supporting static IP address distribution
Supports static IP and dynamic IP
Supports UPnP
LAN
Supports 802.1d Spanning Tree
Web-based (HTTP) management interface
Supports SNTP synchronization
Easy firmware upgrade via HTTP/TFTP (through AP controller)
Easily locate deployed APs through the LED control
Supports SNMP management, LED On/Off control, Schedule Reboot
Supports Smart Discovery Utility, System Log
System Management
Supports WAPC series of AP controllers for central management
Max. WDS Peers 8
IEEE Standards
IEEE 802.11n (2T2R, up to 300Mbps)
IEEE 802.11g
IEEE 802.11b
IEEE 802.11i
IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3x flow control
Other Protocols and CSMA/CA, CSMA/CD, TCP/IP, DHCP, ICMP, SNTP
To Next Page
Loading...
