User Manual of WNAP-W2201A
-30-
Associated Clients Click “Show Active Clients” to show the status table of active wireless
clients.
Enable Universal
Repeater Mode
(Acting as AP and client
simultaneously)
Universal Repeater is a technology used to extend wireless coverage.
To enable Universal Repeater mode, check the box and enter the
SSID you want to broadcast in the field below. Then please click
“Security” in the submenu for the related settings of the AP you want
to connect with.
Multiple-SSIDs
Enabling multiple-SSIDs can broadcast multiple WLAN SSIDs using virtual interfaces. You can have
different encryption settings for each WLAN and you can restrict what they have access to.
Choose menu “WLAN Basic Settings Multiple AP” to configure the device as a general wireless
access point with multiple SSIDs.
Figure 5-15 Wireless Basic Settings – Multiple APs
The device supports up to four multiple Service Set Identifiers. You can go back to the Basic Settings page
to set the Primary SSID. The SSID’s factory default setting is PLANET_XXXX (Multiple-SSID 1~4). The
SSID can be easily changed to connect to an existing wireless network or to establish a new wireless
network. When the information for the new SSID is finished, click Apply Changes to let your changes take
effect.
To Next Page
Loading...
