User Manual of WNAP-W2201A
-11-
Chapter 3. Hardware Installation
3.1 Installing the AP
Before installing the AP, make sure your PoE switch is connected to the Internet through the broadband service
successfully at this moment. If there is any problem, please contact your local ISP. After that, please install the
AP according to the following steps. Don't forget to pull out the power plug and keep your hands dry.
3.1.1 Installing the AP – WNAP-W2201A
Step 1. Follow the figure below to install WNAP-W2201A.
Figure 3-1 WNAP-W2200 Installation Diagram 1
※ The Ethernet cable should not exceed 8cm in length from the end connecting to PoE port to the part
that goes through the outlet box.
Easy 6-Step Installation
Dismantle the existing panel in the wall
1
Connect network cable to
the PoE Port
2
PoE
LAN
RJ11
Connect Phone wire to
the RJ11 Port
3
PoE
LAN
RJ11
Open the front panel
4
Screw the AP on the wall
5
Place the front panel over AP to
tightly close, and turn it on
6
To Next Page
Loading...
