User Manual of WNAP-W2201A
-44-
5.4.2 Advanced Settings
Choose menu “WLAN Advanced Settings” to configure the advanced settings for the wireless network on
this page. After the configuration, please click “Apply” to save the settings.
Figure 5-29 Wireless Advanced Settings
The page includes the following fields:
Object Description
Fragment Threshold You can specify the maximum size of packet during the fragmentation
of data to be transmitted. If you set this value too low, it will result in
bad performance.
Default is “2346”.
RTS Threshold When the packet size is smaller than the RTS threshold, the access
point will not use the RTS/CTS mechanism to send this packet.
Default is “2347”.
Beacon Interval The interval of time that this access point broadcasts a beacon.
Beacon is used to synchronize the wireless network. Default is “100”.
IAPP IAPP (Inter-Access Point Protocol) enabled is recommended as it
describes an optional extension to IEEE 802.11 that provides wireless
access-point communications among multivendor systems.
Default is “Enabled”.
To Next Page
Loading...
