User Manual of WNAP-W2201A
-13-
Chapter 4. Connect to the AP
This chapter will show you how to configure the basic functions of your AP within minutes.
A computer with wired Ethernet connection to the Wireless AP is required for the first-time
configuration.
4.1 System Requirements
Broadband Internet Access Service (Cable/xDSL/Ethernet connection)
One IEEE 802.3af/at PoE switch (supply power to the WNAP-W2201A)
PCs with a working Ethernet adapter and an Ethernet cable with RJ45 connectors
PCs running Windows XP, Windows Vista, Win 7, Win8, Win10, MAC OS 9 or later, Linux, UNIX or
other platforms compatible with TCP/IP protocols
1. The AP in the following instructions refers to PLANET WNAP-W2201A.
2. It is recommended to use Internet Explore 8.0 or above to access the AP.
4.2 Manual Network Setup -- TCP/IP Configuration
The default IP address of the WNAP-W2201A is 192.168.1.253. And the default Subnet Mask is 255.255.255.0.
These values can be changed as you want. In this guide, we use all the default values for description.
Connect the WNAP-W2201A with your PC by an Ethernet cable plugging in LAN port on one side and in LAN
port of PC on the other side. Please power on the WNAP-W2201A by PoE switch through the PoE port.
In the following sections, we’ll introduce how to install and configure the TCP/IP correctly in Windows 7. And the
procedures in other operating systems are similar. First, make sure your Ethernet Adapter is working, and refer
to the Ethernet adapter manual if needed.
To Next Page
Loading...
