User Manual of WNAP-W2201A
-26-
The page includes the following fields:
Object Description
IP Address
The default LAN IP address of the WNAP-W2201A is 192.168.1.253.
You can change it according to your request.
Subnet Mask Default is 255.255.255.0. You can change it according to your request.
Default Gateway Default is 192.168.1.254. You can change it according to your request.
DHCP
You can select a Disabled, Client, and Server. Default is Client,
meaning the WNAP-W2201A must be connected to a router to assign
IP addresses.
DHCP Client Range
For the Server mode, you must enter the DHCP client IP address
range in the field. And you can click “Show Client” to show the Active
DHCP Client Table.
Static DHCP
Click “Set Static DHCP” and you can reserve some IP addresses for
those network devices with the specified MAC addresses anytime
when they request IP addresses.
Domain Name Default is Planet.
802.1d Spanning Tree You can enable or disable the Spanning Tree function.
Clone MAC Address You can input an MAC address here for using clone function.
UPnP Enable
You can enable or disable the UPnP function. The UPnP feature allows
the devices, such as Internet computers, to access the local host
resources or devices as needed. UPnP devices can be automatically
discovered by the UPnP service application on the LAN.
If you change the IP address of LAN, you must use the new IP address to login the
AP.
When the IP address of the WNAP-W2201A is changed, the clients on the network
often need to wait for a while or even reboot before they can access the new IP
address. For an immediate access to the AP, please flush the netbios cache on the
client computer by running the “nbtstat –r” command before using the device
name of the WNAP-W2201A to access its Web Management page.
To Next Page
Loading...
