28
SCANNING DOCUMENTS
There are 4 different ways to operate the scanner:
1. By scanning from the buttons on the scanner front panel.
2. By scanning from DocAction's Execute menu on the screen.
3. By scanning from the icon in the left side of the DocAction window.
4. By acquiring images from the scanner through our TWAIN interface within
any TWAIN-compliant application programs.
The TWAIN interface and DocAction software are automatically installed to your
system along with the scanner driver.
Attention
Before you start scanning, check the following:
The power of both your computer and
scanner is turned on.
The icon
appears on the Windows
system tray.
Paper is appropriately loaded into the ADF.
S
S
c
c
a
a
n
n
n
n
i
i
n
n
g
g
f
f
r
r
o
o
m
m
t
t
h
h
e
e
S
S
c
c
a
a
n
n
n
n
e
e
r
r
’
’
s
s
F
F
r
r
o
o
n
n
t
t
P
P
a
a
n
n
e
e
l
l
To complete your scanning projects by using the scanner buttons is very easy and
convenient. The number of scanning task displayed on the scanner’s front panel is
configured through DocAction. DocAction offers you quick access to the most
frequently-used scanning functions. They are especially useful when you need to
repeatedly scan with the same settings and send images to the same destination.
Before performing your first scan via scanner buttons, you are recommended to
configure the button settings to your needs and preferences first.
Scan from the Scanner Buttons
1. Make sure to slide the Sheetfed / ADF scan switch to meet your needs. Place
the document or images onto the scanner. (Refer to “
Chapter II. Scanning” of
the Scanner User’s Guide for more information in placing paper into the ADF
properly.)
2. Check current button settings by viewing the Button Configuration window. If
needed, you may also modify settings to meet your current needs. (Refer to
“View Button Settings” and “Configure Button Settings” below for more
information.)
3. Press the UP or DOWN button to select the desired task.
4. Press the Scan button.
To Next Page
Loading...
