44
ISO LUBRICATION SYSTEM
Daily: Check the condition of the PMC Lube Oil in the Iso
Lube Reservoir. Replace the PMC Lube Oil if you see
significant changes in the color or signs of solidification.
Ensure inside of Reservoir is wiped clean.
To replace the Lube Oil, proceed as follows:
1. Remove the Lube Reservoir from its support,
unscrew the Lid and remove the Check Valve from
the Suction Hose.
2. Empty the contaminated Lube Oil in a waste
container and refit the Check Valve in the Suction
Hose.
NOTE! Valve is directional.
3. Clean the Reservoir, refill with Lube Oil, and screw on the Lid and place the Reservoir in
its support.
The system is auto-suction and does not need priming.
To Next Page
Loading...
