5.22
BODY / STEERING / SUSPENSION
4. Remove the (2) upper radiator retaining bolts.
5. Remove the (4) bolts retaining the lower radiator mount
bracket and remove the bracket from the frame.
6. Allow radiator to sag down to allow access to recovery
bottle retaining screws and filler neck retaining screws.
7. Remove both sets of retaining screws and allow the
recovery bottle and filler neck to hang down to access the
(4) bolts retaining the upper radiator mount bracket.
8. Remove the (4) bolts retaining the upper radiator mount
bracket and remove the bracket from the frame.
9. Lift up on the stabilizer bar and remove it from the vehicle.
10. Inspect the stabilizer bar for straightness. Inspect the
bushings and replace if needed.
11. Reverse the procedure for installation. Torque the linkage
fasteners to 27-33 ft. lbs. (37-45 Nm).
Exploded View
Filler
Neck
Recovery
Bottle
Main
Frame
Mount
Bracket
Clamp
Stabilizer
Bushings
Grease
Zerk
Linkage
Nuts
Spacer
Clamp
Bar
27-33 ft. lbs.
(37-45 Nm)
Linkage
T30
Screws
To Next Page
Loading...
