To Next Page

To Previous Page

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

6.9

SHIFT CABLE ADJUSTMENT

1. Locate the shift cable (A) attached to the mount

bracket (B) and transmission in the right rear wheel

well area.

2. Inspect shift cable (A), dust boot (C) and the clevis

pin and pivot bushings (D). Replace if worn or

damaged.

3. If adjustment is required, loosen the lower jam nut

(E) and pull the cable out of the mount bracket to

move the upper jam nut (F).

4. Adjust the shift cable so there is the same amount of

cable travel when shifting slightly past HIGH gear

and PARK.

5. Thread the upper or lower jam nut as required to

obtain proper cable adjustment.

NOTICE

This procedure may require a few attempts to obtain

the proper adjustment.

6. Once the proper adjustment is obtained, place the

shift cable and upper jam nut into the mount. Tighten

the lower jam nut (E) against the mount.

7. Start engine and shift through all gears to ensure the

shift cable is properly adjusted. If transmission still

ratchets after cable adjustment, the transmission will

require service.

TRANSMISSION

Polaris GENERAL 2018 User Manual

Questions and Answers: