Polaris Ranger 500 2x4 2007 - Driven Clutch Service; Exploded View; Clutch Disassembly; Inspection

6.19
CLUTCHING
6
DRIVEN CLUTCH SERVICE
Exploded View
Clutch Disassembly / Inspection
1. Apply and hold downward pressure on the helix, or place
driven clutch in the Clutch Compression Tool
(PN 8700220).
2. Remove snap ring retainer.
3. Note the location of the spring and remove helix.
4. Note the location of the spring in the moveable sheave, and
remove the spring.
5. Check alignment of tabs on spring. Replace the spring if
tabs are misaligned or the spring coils are distorted.
Button Ramp
Inner Sheave
Spacer Shims
Outer Sheave
Driven Clutch Bolt
Moveable Bearing
Stationary Ramp
Clutch Spring
DRIVEN CLUTCH
CAUTION
Wear eye protection when removing snap ring to
prevent serious personal injury.