2.27
MAINTENANCE
2
To change gearcase lubricant:
1. Remove gearcase drain plug (B) (11 mm) located on the
bottom of the gearcase and drain oil. (The drain plug is
accessible through the skid plate.) Catch and discard used
oil properly.
2. Clean and reinstall drain plug (B) using a new sealing
washer (A). Toque to 10 ft.lbs. (14 Nm).
3. The fill plug can be accessed through the top hood area by
removing the storage box or by removing the left side panel
in the left wheel well.
4. Remove fill plug (8 mm hex) and check the O-ring.
5. Fill with the recommended fluid amount (5 oz.) or to the
bottom of the fill plug hole threads.
6. Install fill plug and check for leaks.
Rear Gearcase Lubrication
To ch eck t he le vel:
1. With machine on level ground and with the parking brake
on, remove fill plug from rear gearcase.
10 ft. lbs (14 Nm)
A
B
Top View of Ho o d A re a
LH Side Panel
REAR GEARCASE SPECIFICATIONS
Specified Lubricant:
ATV Angle Drive Fluid (PN 2871653)
Capacity: 18 oz. (532 ml)
Fill Plug Torque: 40 ft. lbs. (54 Nm)
Drain Plug Torque: 30-45 in. lbs. (3-5 Nm)
Fill Plug
Front Gearcase
Plug Threads
Fill with 5 oz.
To Next Page
Loading...
