10.7
ELECTRICAL
10
Indicator Lamp Replacement
1. Lift the hood.
2. Reach in behind the console panel and lift on the release to
unplug the light from the harness.
3. Using a small flathead screwdriver, press on the tab on top
of the light to remove the indicator panel from the console.
4. To remove defective lamp: Use a small screwdriver and
turn lamp holder a quarter turn, pull the bulb assembly out
with a needle nose pliers or equivalent. Replace with a new
bulb.
5. Reverse the disassembly procedure to reinstall the indicator
panel.
HEAD LIGHTS
High Beam Headlight Adjustment
The headlight beam is adjustable.
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
2. Measure the distance from the floor to the center of the
headlight and make a mark on the wall at the same height.
3. With the machine in Neutral and park brake applied, start
the engine and turn the headlight switch to high beam.
4. The most intense part of the headlight beam should be
aimed 8 in. (20 cm) below the mark placed on the wall in
Step 2.
NOTE: Rider weight must be included in the seat
while performing this procedure.
5. Adjust the beam to the desired position by loosening the
adjustment screw (A) and moving the lamp to the
appropriate height.
Rear View of Indicator Panel
1/4 Turn To Remove
Replacement Bulbs
PN 4010416
XX
25 ft.
(7.6 m)
8 in. (20 cm)
A
To Next Page
Loading...
