7.24
FINAL DRIVE
6. If a tight spot is felt during rotation, loosen the backlash
screw another 1/8 turn. Perform the previous step again.
Repeat this procedure until the pinion shaft rotates
smoothly 4 times (1 revolution of ring gear).
Gearcase Installation
1. To install gearcase, reverse removal procedure.Use new
spring pin in front prop shaft.
2. Torque mounting bolts to 30 ft.lbs. (41 Nm).
3. Add the proper lubricant to the front gearcase. Check drain
plug for proper torque. Refer to Chapter 2 for fluid fill and
change information.
Front Housing Mount Bolt Toque:
30 ft. lbs. (41 Nm)
Premium Front Drive Hub Fluid
(PN 2871654)
Front Housing Capacity
5 fl. oz. (148 ml)
4 Bolts
30 ft. lbs. (41 Nm)
To Next Page
Loading...
