Polaris Ranger 500 2x4 2007 - Pdm Block Diagram; Pdm Isolation Tests (Non-Efi Models); Battery Voltage Test

10.11
ELECTRICAL
10
PDM Block Diagram
PDM ISOLATION TESTS (NON-EFI MODELS)
Battery Voltage Test
Battery Voltage Test
Test Procedure Check DC volts across positive and negative battery terminals. Voltage should be above 12 VDC.
What does passing
this test indicate?
If battery voltage is at or above 12 VDC, the battery and charging system are likely OK.
What does failing
this test indicate?
If battery voltage is below 12 VDC, the battery and charging system may be suspect. The battery must
be charged and load tested.