10.28
ELECTRICAL
Components of DC / CDI Ignition
Resistor
Cap
Battery Charging Coils
Flywheel and
Ring Gear Casting
CDI Box
Stator
Plate
Pulse Coil (Trigger)
Air Gap: .016-.030”
(.4-.75 mm)
Ignition
Coil
Check coil mount for good
ground to engine (0 - .2
Ω)
Meter
6.7 k
Ω
NOTE: CDI boxes may look the same but have
different internal circuitry. Be sure to always use
the correct CDI box part number.
Refer To Wiring Diagrams For
Specified Stator Coil Resistance
Meter
5 k
Ω
To Next Page
Loading...
