6.22
CLUTCHING
3. Install sheave onto puller with new bushing upward as
shown. Install Puller Adapter (#10) (PN 5020633).
4. Install nut onto puller rod and hand tighten against
installation tool.
5. Turn clutch sheave counterclockwise until bushing is
seated.
6. Remove nut from puller rod and set aside.
7. Remove installation tool and clutch sheave from puller.
8. Repeat installation procedure for other moveable bushing.
Clutch Assembly
1. Install moveable sheave with spacer washers. Important:
At least one spacer washer must be installed. Teflon™
bushings are self-lubricating. Do not apply oil or grease to
the bushings.
2. Install spring, inserting spring tab into proper hole in
moveable sheave.
3. Insert spring tab into proper hole in helix. See “Clutch
Chart” of the specifications page in Chapter 1.
The driven clutch, helix/moveable assembly has several
different spring locations which affect clutch shifting and
RPMs. The greatest amount of spring tension will raise engine
RPMs during clutch upshift and allow quicker backshift or
downshift when pulling or negotiating a hill, for example. The
least amount of tension will create a slower downshift and a
harder upshift.
Example: Helix Sheave Tension
2 - 1 Heavy
Spring/ 2 - 2
Position 1 - 1
2 - 3
1 - 2
1 - 3 Soft
Refer to General Information Chapter 1 for
driven clutch spring color and production setting.
Moveable Spring
Driven Clutch
Driven Spring
Driven Spring Placement:
RANGER 2x4: 2-2
RANGER 4x4: 2-2
To Next Page
Loading...
