Polaris Ranger 500 2x4 2007 - Page 64

3.5
ENGINE
3
Engine Service Data
KEY - Std: Standard; OS: Oversize; ID: Inner Diameter; OD: Outer Diameter; Mag: Magneto Side;
PTO: Power Take Off Side.
Cylinder / Piston / Connecting Rod EH50PLE
Cylinder
Surface warpage limit (mating with cylinder head) .0020” (0.05 mm)
Cylinder bore Std 3.6221-3.6228" (92.00-92.02 mm)
Taper li m i t .0020 ” ( 0 .050 mm )
Out of round limit .0020” (0.050 mm)
Piston clearance
Std .0006-.0018" (0.015-0.045 mm)
Limit .0024" (0.060 mm)
Boring Limit .020” (.5 mm)
Piston
Outer diameter
Std 3.6204-3.6215" (91.970-91.985 mm)
.0098" (.25 mm) OS 3.6304-3.6310" (92.21-92.23 mm)
.0197" (.50 mm) OS 3.6403-3.6407" (92.46-92.47 mm)
Standard inner diameter of piston pin bore .9055-.9057" (23.0-23.006 mm)
Piston Pin
Outer diameter .9053-.9055” (22.994-23.0 mm)
Standard clearance - piston pin to pin bore .0002- .0003” (.004- .008 mm)
Degree of fit
Piston Pin must be a push (by hand) fit at 68
o
F (20
o
C)
Piston Ring Piston Ring Installed gap
Top ri n g
Std .0079-.0138" (.20-.36 mm)
Limit .039" (1.0 mm)
Second
ring
Std .0079-.0138" (.20-.36 mm)
Limit .039" (1.0 mm)
Oil ring
Std .0079-.0276" (.20-.70 mm)
Limit .059" (1.5 mm)
Piston Ring
Standard clearance -
piston ring to ring groove
Top ri n g
Std .0016-.0031" (.040-.080 mm)
Limit .0059" (.15 mm)
Second
ring
Std .0012-.0028" (.030-.070 mm)
Limit .0059" (.15 mm)
Connecting Rod
Connecting rod small end ID .9058 - .9063” (23.007 - 23.020 mm)
Connecting rod small end radial clearance
Std .0003-.0010" (.007-.026 mm)
Limit .0020" (.05 mm)
Connecting rod big end side clearance
Std .0039-.0256" (.1-.65 mm)
Limit .0315" (.80 mm)
Connecting rod big end radial clearance
Std .0004-.0015" (.011-.038 mm)
Limit .0020" (.05 mm)
Crankshaft Crankshaft runout limit .0024" (.06 mm)