10.28
9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual
© Copyright Polaris Inc.
REAR PAD INSTALLATION
1. Install new pads in caliper body.
2. Install caliper and torque mounting bolts.
TORQUE
Rear Brake Caliper Mounting Bolts:
46 ft-lbs (62 Nm)
3. Turn adjuster screw back in finger tight using a hex
wrench. Then back off 1/2 turn.
4. Slowly pump the brake pedal until pressure has been
built up. Maintain at least 1/2"(12.7 mm) of brake
fluid in the reservoir to prevent air from entering the
master cylinder.
5. Fill master cylinder to Max level.
6. Burnish brakes as outlined in this chapter.
BRAKE SYSTEM
To Next Page
Loading...
