ENGINE
3.47
Grease Cam Lobes
Grease Lifters
9. Lubricate lifters with engine oil and install in the
original order as removed in disassembly. Apply
Lubriplate to the ends of the lifters.
NOTE: Always replace the camshaft and lifters as
a set.
10. Lubricate connecting rods with engine oil.
11. Install new cylinder gasket on cylinder.
NOTE: Apply a small amount of grease to the cylinder
gasket to help hold it in place during cylinder
assembly. DO NOT USE SILICONE.
12. Install piston assemblies into cylinder aligning the
piston pin holes, to ensure proper alignment of the
pistons to the connecting rods upon assembly.
Partially install the piston pins into the pistons.
Cylinder Installation
NOTE: To help align the pistons, slide a rod that is
close to the same diameter as the wrist pin holes to
properly align them in the cylinder.
13. Position cylinder and piston assemblies onto the
connecting rods and push the piston pins through
the piston and pushrod.
Enfocus Software - Customer Support
To Next Page
Loading...
