Polaroid ModelSmart 250S User Manual

30
CERTIFICATIONS AND COMPLIANCE
CERTIFICATION
The Polaroid ModelSmart 250S printer is compliant under the following applicable EU certications:
WEEE Directive: As both manufacturer and distributor the Polaroid 3D printer team is WEEE
compliant in all applicable EU countries in which the product is supplied. This ensures that our
responsibilities are fullled in regards to the electronic waste that is generated through the
sale of the Polaroid 3D printers and consumables.
Low Voltage Directive 2006/95/EC: This Directive allows electrical equipment to be
approved by any EU member country, by provision of a set of common broad objectives,
covering safety regulations that the product is tested against. The Polaroid ModelSmart 250S
printers are tested and approved under this Directive.
EMC Directive 2004/108/EEC: This is a Directive that all electronic items must be tested
against. It aims to minimise the side effects that can sometimes be seen when electrical devices
are interconnected or close to each other; e.g. the interference that you sometimes hear when
your mobile phone is near your TV or radio. The Polaroid ModelSmart 250S printers are tested
and approved under this Directive.
RoHS Directive 2011/65/EU: This is the Restriction of Hazardous Substances Directive. Its
purpose is to restrict the use of six hazardous materials in the manufacture of various types
of electronic and electrical equipment. Each individual component of the equipment has been
tested in order to ensure that the Polaroid ModelSmart 250S printers are approved under this
Directive.
Green Dot Packaging Waste Directive - 94/62/EC: This directive ensures that manufacturers
whose products use packaging are responsible for either recovering their own packaging waste,
or contributing to the cost of recovery and recycling of such waste. The Polaroid 3D team is
registered and compliant against this directive across the applicable European countries.
CE Marking: Following all of the above required legislation and certication enables each of
the Polaroid ModelSmart 250S printers to proudly carry the CE Mark which conrms that they
have been approved under each of these Directives.

Polaroid ModelSmart 250S Specifications

General

Print technology	-
Printing material	Polylactic acid (PLA), Wood fiber
Maximum travel speed	100 mm/sec
Layer thickness (max)	350 mm
Layer thickness (min)	50 mm
Maximum build size (WxDxH)	250 x 150 x 150 mm
Filament thickness supported	1.75 mm
Control type	Wireless
Viewing window	Yes
Print resolution	- DPI
3D scanner	No
Compatible memory cards	SD
AC adapter output voltage	24 V
Cables included	AC, USB

Weight and Dimensions

Depth	150 mm
Width	250 mm