Polycom CX5000 - Using Call Controls

Polycom CX5000 Deployment Guide
30 Polycom, Inc.
Property
Value2
Value3
the format of 1.0.xxxx.x
HCD1: Initialize
PASS | FAIL
Status code
HCD3: Initialize
PASS | FAIL
Status code
LCD VERIFY
PASS | FAIL
Status code
NANDFLASH VERIFY
PASS | FAIL
Status code
NORFLASH VERIFY
NOT DONE
Reserved
OS REV
NA
Revision number for working version nk.bin in the
format of 1.0.xxxx.x
POST Version
NA
Reserved
PSTN
PASS | FAIL
Initialization
RTC VERIFY
PASS | FAIL
Status code
SDRAM TEST
PASS | FAIL
Status code
System Cable
PASS | FAIL
Status code
TOUCHCTL VERIFY
PASS | FAIL
Status code
UFN1: Initialize
PASS | FAIL
Status code
USBF ENUM STATUS
PASS | FAIL
Status code
USBH ENUM STATUS
PASS | FAIL
Status code
VDSP ENUM STATUS
PASS | FAIL
Status code
When component = VDSP, only the Property, Value2, and Value3 columns are used.
The Property column contains the name of the test. The Value2 column contains the status (PASS |
FAIL | NOT DONE | NA). The Value3 column contains the detailed status code. These entries indicate
the general health of the video subsystem.
Table 19 shows the possible values in the Property, Value2, and Value3 columns when the Component
value is VDSP.
Table 19. Properties and Values for POST Logging, Component == VDSP
Property
Value2
Value3
Calibration
PASS | FAIL
OK | FAIL
Camera ID
PASS | FAIL
The camera ID
Camera Video
PASS | FAIL
XXXXX
The health of each of the five cameras. X can be Y or N,