Polycom CX5000 Deployment Guide
Polycom, Inc 31
with Y = Pass and N = Fail
Number of restarts since boot
When Component = ADSP, only the Property, Value2, and Value3 columns are used.
The Property] column contains the name of the test. The Value2 column contain the status (PASS |
FAIL | NOT DONE | NA). The Value3 column contains the detailed status code. These entries indicate
the general health of the initialization phase of the audio sub-system.
Table 20 shows the possible values in the Property, Value2, and Value3 columns when the Component
value is ADSP.
Table 20. Property and Values for POST Logging, Component == ADSP
There are two types of health logging: system performance and usage.
This section discusses system performance logging. Usage logging is discussed in the next section.
System performance refers to memory usage, system uptime, and health of the audio digital signal
processor.
Table 21 shows the columns used and values logged in health logging.
Table 21. Columns and Values Used in System Performance Logging
For performance logging, only the Component, Subcomponent, Property, and Value1 columns are
used.
0 shows the possible values of these columns for System (either memory usage or uptime) and for
audio digital signal processor (ADSP) health.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
