SoundStation2™ User Guide - 15
Adding a call
1. While on an active call, press the
Conference button . The rst
call is automatically placed on
hold.
2. Dial the number you wish to call.
You may use the Redial or Direct
Dial method.
3. Press the Conference button
or JOIN soft key to join the second
call. To drop the second call,
press the Conf key again.
Programming the Bridge number
OR
1. Press the HOLD soft key to place
the rst call on hold.
2. Press the Conference button
and enter the number you wish to
call. You may use the Redial or
Direct Dial method.
Bridge Soft Key
You may program the telephone number of
your preferred audio conferencing bridge or
service into the SoundStation2™ so that it
is immediately available.
1. Press the Menu button, choose
Bridge Setup using the Scrolling
buttons, and press the Select button.
2. Choose Enter Phone Number and
press the Select button and then en-
ter the bridge number using the dial
pad. Enter any necessary prex
such as 9 and/or 1.
► If you make a mistake entering the
number, use the <DEL soft key to
correct the error.
3. Press the SAVE soft key or CANCEL
soft key if you wish to cancel the
procedure.
The SPEED DIAL soft key will not
display when the bridge number
is congured.