Polycom VVX 411 - Registering Phone; Manual Configuration

Reset to factory settings.
This step is not required for out-of-the-box phones, however, if the phone has been already used
then it is a must.
Press Home button.
■
Go to Settings and press the Select button.
■
Go to Advanced and press the Select button.
■
You'll be asked to enter password, enter your password (default password 456), press the
■
Enter button.
Go to Administration Settings and press the Select button.
■
Go to Reset to Defaults and press the Select button.
■
Go to Reset To Factory and press the Select button.
■
Confirm your action by pressing the Yes button.
■
Registering phone
This chapter describes how to identify Polycom phone model, requirements that must be met
and how to register the phone using manual configuration or auto provisioning.
The following topics are covered:
Manual configuration
■
Auto provisioning
■
Manual configuration
This chapter describes how to set UAD settings, create PBXware extension and register the
phone.
The following topics are covered:
UAD settings
■
Creating extension
■
Registering phone
■
UAD Settings
UAD settings