LOCAL LOCKOUT.
The CLASSIC Series Temperature Controller’s controls can be locked to help prevent the cooking
temperature from being inadvertently changed.
To activate this feature, press and hold the Select / Set Knob until LLo is displayed (approximately 10
seconds). When locked, the set point decimal will not flash as usual when the Select / Set Knob is
pressed.
To unlock the controls, press and hold the Select / Set Knob until CAn is displayed (approximately 10
seconds).
CALIBRATION.
If desired, the CLASSIC Series Controller’s temperature display can be adjusted to match an external
reference thermometer. Calibration is performed as follows:
Set the unit to the desired cooking temperature.
When the bath has stabilized at the desired cooking temperature, press the P2 and P3 Buttons
simultaneously, release and repeat until the current calibration offset value (oCx.x) appears on the
display. Press P1 and hold until Cal appears on the display (this will take approximately 2 seconds).
The displayed value will begin alternating between the actual cooking liquid temperature and the current
calibration offset value at one second intervals.
Rotate the Select / Set Knob until the display matches the reference thermometer reading. The maximum
adjustment is ±0.9°C.
Press the Select / Set Knob or the P1 Button to accept the entered value. (dONE) will appear briefly on
the display when the new calibration offset is accepted.
NOTE: The calibration offset value will also be automatically accepted after approximately
20 seconds of inactivity, even if the Select / Set Know or P1 Button is not pressed.
LOSS OF POWER.
In the event that electrical power is disrupted during use, your Circulator will return to operation when
power is restored.
CLASSIC Series 13 www.cuisinetechnology.com
Precise Temperature Cooking Systems
To Next Page
Loading...
Need help?
General
