42
SP > Spectrum
Normal >Normal operation
Invers > The spectral position
of the useful signal can be
inverted. Inversion is only
necessary in exceptional
cases.
On OFF > Switching off the
output channel
If not all 4 output channels are
to be used, each channel can
be switched off by selecting
OFF.
H/V > Entering the polarization plane
for the generation of the correct
NIT information
Selection of the polarization
plane of the output channels
Set > Apply the programming
After all parameters have been
adjusted, click the button Set .
This applies all of the entered
settings. Repeat this step for
the remaining channels.
Notice: The DVB-S/S2 receivers must be programmed in
accordance with the set parameters (search).
To Next Page
Loading...