61EGW05-SWHPEG-20140724
TM
TM
5. REFRIGERANT CHARGE: Check the two sight glasses located in the valve compartment on the end of the
evaporator coil. When the refrigerant charge is correct, there should be no bubbles in the sight glasses. Intermittent
bubbles are normal during the rst 10 minutes of operation or following a change in stages or operating mode.
6. CONDENSATE LINE: Ensure that it is free of obstructions. Always keep the condensate trap and lines free and
clear. The PoolPak™ is capable of producing up to 40 gallons of condensate per hour.
7. UNIT INTERIOR/EXTERIOR: Check for torn insulation and repair if necessary. Check for scratches, nicks, rust,
etc. and repaint promptly using Fox Gard Gray, Part No. 13-0008Z003.
8. LOGBOOK: Check and record, in the logbook, the following actual operating values and the values read from the
ECCIII controller display:
◦ Space Temperature
◦ Space Relative Humidity
◦ Pool Water Temperature
◦ Pool Water Free and Total Chlorine
9. DAMPER OPERATION: Ensure that dampers open and close fully without binding.
ANNUAL MAINTENANCE
Perform the following on an annual basis:
1. All items listed under MONTHLY MAINTENANCE.
2. COMPRESSOR AND REFRIGERATION SYSTEM: The compressor and refrigeration system should be inspected
annually by a qualied service technician. At minimum, the following items should be done:
◦ Change and inspect the refrigerant lter drier (only if the system has been open).
◦ Complete unit operation test including log entries.
◦ Inspect fan bearings and belts for excessive wear and replace if necessary.
◦ General refrigeration system inspection for possible leaks, chang between tubing, or other items detrimental to
operation.
◦ Touch up scratches in the paint.
◦ Check electrical connections for tightness including those in the compressor electrical box.
◦ Clean debris and dirt from drain pans.
To Next Page
Loading...
