- 7 -
6. Input and Use of Program
6.1 How to input user's program
How to input user's program A
If you hold the button “Program A” for more than 3seconds, the whole LED of the
front part flickers twice and display the chart “C”
Select the chart that you want and press the button “NEXT”, then the whole LED of
front flickers once.
You can repeat above process as many as you want to. (40 programs can be input in
total)
- Program button -> chart button -> NEXT button -> chart button -> NEXT button ->
chart bu
Tton -> NEXT button ……
In case you want to check the previous program while you’re inputting a new one,
you can check the previous one when you press “NEXT”.
If you press the button “Program A” once, the whole LED of the front part flickers
twice and the new program is saved.
NOTE
If you do not press the "Program A" button, the program will not be
saved (If you turn off and turn on, a program will be deleted.).
On the time of delivery, the chart is input on user program A in
accordance with the chart of remote control.
How to input user's program B
“How to input user’s program A” in the “Program A” button instead of “Program B”
button is used.
On the time of delivery, there is no program on “User program B”
6.2 How to use your stored programs
When you press “Program A” or “Program B”, the first chart of chosen program
appears.
When you press “Next” button, you may move to a next chart.
When you press “Back”, you may move to a previous chart.
When you chose your preference, “User program call” is finished.
If “PC Communication” in user menu Setting, cannot “Program A” or
“Program B”. Used only PC Communication button.
To Next Page
Loading...
