EasyManua.ls Logo

Potec PLC-8000 - Maintenance and Repair; Replacement the Battery of Remote Controller; Cleaning; Service Information

Potec PLC-8000
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 45 -
28. Maintenance and Repair
28.1 Replacement the Battery of Remote Controller
Remove the battery cover of the remote controller
Replace the batteries and the battery cover to the remote controller
WARNING
Be sure to observe the polarity marks (plus + & minus -) inside the
battery compartment. Remove these batteries if equipment is not
likely to be used for some time. Follow local governing ordinances
and recycling plans regarding disposal or recycling of device
components.
28.2 Cleaning
Wipe the cover and the screen with a dry soft cloth when they get dirty.
28.3 Service Information
You cannot solve the problem device sales representative to request a consultation.
Show product labels and distributors to use the information below, please let us know.
Model Name: PLC-8000 or PLC-8000pola
Product Number: Display products on the label says the 8-digit character
Symptoms: A detailed technical
If you can’t contact with your local distributor, you can directly get in touch with the
service department of the POTEC using the phone number and the address written
in the below table.
Manufacturer: POTEC Co., Ltd.
Address: 40-4, Techno 2-ro, Yuseong-gu, Daejeon, 34015, KOREA
Tel: +82-42-632-3536
Fax: +82-42-632-3537
Disposal of equipment
WARNING
This equipment has battery that can cause environment pollution
when be left. Ahead of going into the discard, ask way to do it or
consult with selling agency
WARNING
Upon request, circuit diagrams, component part lists, descriptions,
calibration instructions, or other information will be provided to
assist service personnel to repair parts of the equipment that are
designated by POTEC as repairable by service personnel.

Table of Contents

Related product manuals