Powered by Safety
®
iii
01.4IB.67000
Figure 1 Typical Indoor Power/Vac® Metal-Clad Switchgear Lineup ..........................6
Figure 2 Typical Outdoor Power/Vac® Metal-Clad Switchgear Lineup .......................7
Figure 3 Interior Metal-Clad Switchgear (Lower Compartment) ................................8
Figure 4 Primary Disconnecting Device - 1200A .......................................................12
Figure 5 Primary Disconnecting Device - 3000A .......................................................12
Figure 6 Installation Details for Indoor Power/Vac® Metal-Clad Switchgear ...........18
Figure 7 Installation Details for Indoor Power/Vac® Metal-Clad
Switchgear (cont.) ........................................................................................19
Figure 8 Installation Details for Outdoor Power/Vac® Metal-Clad Switchgear ........20
Figure 9 Installation Details for Outdoor Power/Vac® Metal-Clad
Switchgear (cont.) ........................................................................................21
Figure 10 Installation Details for Outdoor Power/Vac® Metal-Clad Switchgear with
Protected Aisle .............................................................................................22
Figure 11 Typical Assembly Details .............................................................................24
Figure 12 Typical Assembly Details (cont.) ..................................................................25
Figure 13 Assembly of Outdoor Switchgear with Protected Aisle ...............................28
Figure 14 Assembly of Outdoor Switchgear with Protected Aisle - (cont.) .................29
Figure 15 Front Upper Compartment ..........................................................................32
Figure 16 View Looking Up Into Front Bottom Compartment of a 2-High .................32
Figure 17 Taptite Location in Front Upper Compartment ...........................................32
Figure 18 View of Typical Front Lower Breaker Compartment ...................................32
Figure 19 View of Typical Front Lower PT/CPT Rollout Compartment ........................33
Figure 20 View of Main Bus Compartment from Front ...............................................33
Figure 21 Location of Tape ........................................................................................... 33
Figure 22 Typical Bus Compartment with Polyester Glass Inter-Unit Bus Support ....34
Figure 23 View Showing Stacks Bolted Together ........................................................34
Figure 24 Single Bus Bar Arrangement ........................................................................35
Figure 25 Double Bus Bar Arrangement ......................................................................35
Figure 26 Typical Rear Tie Bus Compartment with Bus Barrier Removed ..................35
Figure 27 Sectional View of Inter-Unit Bolting ............................................................37
Figure 28 Typical Center Post Bolting ..........................................................................37
Figure 29 Ground Bus Splice Bolt Assembly ................................................................38
Figure 30 Insulation of Bus Bar ....................................................................................40
Figure 31 Single Bus Bar Connection Joint ..................................................................41
Figure 32 Double Bus Bar Connection Joint ................................................................41
Figure 33 Tee Connection Joint .................................................................................... 42
Figures
To Next Page
Loading...