Danger
During normal operation of this device, hazardous voltages are present which
can cause severe injury or death. These voltages are present on the terminal
strips of the device and throughout the connected potential transformer (PT),
current transformer (CT), status input, relay, and control power circuits. Installa-
tion and servicing should be performed only by qualified, properly trained
personnel. See Chapter 2: Installation for additional warnings.
Warning
This equipment generates, uses, and can radiate radio frequency energy and if
not installed and used in accordance with the instructions manual, may cause
interference to radio communications. It has been tested and found to comply
with the limits for a Class A computing device pursuant to Part 15 of FCC Rules,
which are designed to provide reasonable protection against such interference
when operated in a commercial environment. Operation of this equipment in a
residential area may cause interference in which case the operator will be
required to take whatever measures may be required to correct the interference.
Limitation of Liability
Power Measurement Limited reserves the right to make changes in the devices
or the device specifications identified in this Installation and Operation Manual
without notice. Power Measurement Limited advises customers to obtain the
latest version of device specifications before placing orders to verify that the
information being relied upon by the customer is current.
In the absence of written agreement to the contrary
Power Measurement
Limited assumes no liability for Power Measurement Limited applications
assistance, customer’s system design, or infringement of patents or copyrights of
third parties by or arising from the use of devices described herein. Nor does
Power Measurement Limited warrant or represent that any license, either
expressed or implied, is granted under any patent right, copyright, or other
intellectual property right of Power Measurement Limited covering or relating
to any combination, machine, or process in which such device might be used.
EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, UNDER NO
CIRCUMSTANCES SHALL POWER MEASUREMENT LIMITED BE LIABLE FOR
CONSEQUENTIAL DAMAGES SUSTAINED IN CONNECTION WITH SAID
PRODUCT AND POWER MEASUREMENT LIMITED NEITHER ASSUMES NOR
AUTHORIZES ANY REPRESENTATIVE OR OTHER PERSON TO ASSUME FOR
IT ANY OBLIGATION OR LIABILITY OTHER THAN SUCH AS IS EXPRESSLY
SET FORTH HEREIN.
3300 ACM is a trade mark of Power Measurement Limited. Other brands and
their products are trade marks of their respective holders and should be noted as
such.
© 1999 Power Measurement Ltd.
The information contained in this document is believed to be
accurate at the time of publication, however, Power Measurement
Ltd. assumes no responsibility for any errors which may appear
here and reserves the right to make changes without notice.
Toll Free
1-877-METER-IT
(1-877-638-3748)
World-Wide Web www.pml.com
Worldwide Headquarters
POWER MEASUREMENT LTD.
2195 Keating Cross Road,
Saanichton, BC,
Canada V8M 2A5
Tel: 1-250-652-7100
Fax: 1-250-652-0411
Europe & Middle East
POWER MEASUREMENT EUROPE
Zaventem Business Park, Ikaroslaan 5,
B-1930 Zaventem
(Brussels), Belgium
Tel: 32-2-720-19-19
Fax: 32-2-720-95-86
Asia & Pacific
POWER MEASUREMENT
AUSTRALIA
7/16 Ledgar Road,
Balcatta, Perth
Western Australia 6021
Tel: 61-89-345-3866
Fax: 61-89-345-3899
Revision Date: February 1, 1999
© 1999 Power Measurement Ltd.
All rights reserved
Printed in Canada
70000-0012
For further information or technical assistance, please
contact your local Power Measurement representative,
or Customer Service at one of the following locations:
ISO 9002-94
Registration
Cert # 002188
Courtesy of NationalSwitchgear.com
To Next Page
Loading...
Need help?
General
