powersoft K2 - Removing the Heatsink

23
K2 K3 | SERVICE MANUAL
INDEX
Removing the Heatsink:
Using a socketed screwdriver unscrew all 12 bolts
highlighted in (Fig. 20).
With a thin piece of strong plastic, pry all the components
off the heatsink so that a little gap is formed between the
two, as portrayed in (Fig. 21)
It is now possible to safely remove the heatsink by simply
pulling vertically on it, making sure not to damage the
tube containing the R127A resistance (Fig. 22).
(Fig. 20)
(Fig. 21)
(Fig. 22)