powersoft K2 - Page 6

6
K2 K3 | SERVICE MANUAL
INDEX
If the LEDs are still on discharge the capacitors bank
by connecting a 40 W/230V lamp to the connectors
portrayed in (Fig. 4)
Lamp (min.40W/230V, best 60W/230V)
(Fig. 4)
Once the amplier is open and its power supply fully discharged, it is possible to start removing the single boards. (Fig. 5)
(Fig. 5)
AMP BOARD
CNTRL BOARD
FILTER SECTION
DC/DC CONVERTER
POWER SUPPLY