To Next PageTo Next Page
Need help?Do you have a question about the PowerSource YDC3300 and is the answer not in the manual?
General| Category | UPS |
|---|---|
| Frequency | 50/60Hz |
| Battery Type | Sealed Lead Acid |
| Battery Recharge Time | 4-6 hours |
| Communication Port | USB |
Important safety precautions for operating the UPS, including electrical hazards and environmental considerations.
Explanation of warning and caution symbols used throughout the manual to indicate potential risks.
Overview of the UPS series capabilities, specifications, and modular design.
Details on digital control, configurable battery options, and intelligent three-stage charging methods.
Procedures for unpacking the UPS, checking for damage, and verifying accessories.
Diagrams showing the front, side, and rear views of the UPS cabinet.
Identification and explanation of the UPS's LCD panel, buttons, and LED indicators.
Guidelines for appropriate environment, temperature, humidity, and altitude for UPS installation.
Requirements for installing external circuit breakers for AC input and battery connections.
Information on selecting appropriate power cables based on UPS capacity and ratings.
Detailed instructions for connecting input, output, and battery power cables to the UPS.
Guidelines for correctly connecting battery strings, including polarity and configuration.
Procedures for installing and connecting multiple UPS modules in a parallel system.
Instructions on connecting the UPS to a PC for monitoring and configuration via software.
Description of various UPS operating modes: Normal, Battery, Bypass, ECO, and Maintenance.
Step-by-step procedures for safely powering the UPS on, off, and restarting it.
Instructions for performing system self-tests and load testing on the UPS.
Procedure to switch the UPS to mechanical bypass mode for maintenance activities.
Guide for initiating the UPS startup sequence from a completely powered-off state.
Steps to correctly power down the UPS and its connected load.
Configuration steps for setting up UPS units to operate in parallel.
Detailed overview of the UPS LCD interface, including status indicators and available screens.
Instructions for configuring the UPS operational mode (ECO, PAL, NOR) via the control panel.
Procedure to adjust the UPS output voltage levels through the parameter settings.
How to set the desired output frequency for the UPS from the available options.
Configuring the UPS to match the specific capacity (Ah) of the connected batteries.
Setting the number of battery cells connected to the UPS for accurate operation.
Defining the permissible upper voltage limit for the UPS bypass mode.
Defining the permissible lower voltage limit for the UPS bypass mode.
Instructions on how to enable or disable audible alarms (mute) on the UPS.
Assigning a unique identification number to each UPS in a parallel configuration.
Specifying the total number of UPS units operating in a parallel system.
Configuring the redundancy level for parallel UPS operations to enhance reliability.
A guide to understanding UPS status messages, alarm codes, and troubleshooting common issues.
Information about optional accessories such as SNMP cards and relay cards for enhanced monitoring.
