7-- 1
Powerware 9315 (500 kVA--750 kVA) T1 and T3 Installation Addendum
164201244--001 REV. A 011500
Final Assembly
7.1 Output/Inverter Cabinet
To install rear panels and front doors, perform the following procedure:
1. Install four rear panels onto cabinet as follows (see figure 4---2):
a. Install panel 4 over four screws at bottom of cabinet base. Secure with
six screws on sides of panel and four at the bottom of panel.
b. Install panel 3 over four screws at bottom of cabinet base. Secure with
six screws on sides of panel and four at the bottom of panel.
c. Install panel 2 above panel 4, inserting screws in bottom of panel into
slots at the top of panel 4. Secure with ten screws on top and sides
and four screws at bottom of panel.
d. Install panel 1 above panel 3, inserting screws in bottom of panel into
slots at the top of panel 3. Secure with ten screws on top and sides
and four screws at bottom of panel.
2. Install doors and top door hinges.
7.2 Input/Rectifier Cabinet
To install rear panels and front doors, perform the following procedure:
1. Install four rear panels onto cabinet as follows (see figure 5---2):
a. Install panel 4 over four screws at bottom of cabinet base. Secure with
six screws on sides of panel and four at the bottom of panel.
b. Install panel 3 over four screws at bottom of cabinet base. Secure with
six screws on sides of panel and four at the bottom of panel.
c. Install panel 2 above panel 4, inserting screws in bottom of panel into
slots at the top of panel 4. Secure with ten screws on top and sides
and four screws at bottom of panel.
d. Install panel 1 above panel 3, inserting screws in bottom of panel into
slots at the top of panel 3. Secure with ten screws on top and sides
and four screws at bottom of panel.
2. Install doors and top door hinges.
3. Proceed to installation of UPS contained in manual referenced in the
Introduction of this manual.
7
To Next Page
Loading...
