The Supervisory Parameters are grouped on Supervisory Page and pertain to the FLOREX’s supervisory utility features to
exercise the supervisory control over the operator level.
The Table 8.1 below lists the parameters required for the operations of the supervisory utility features followed by definition of
each parameter.
SUPERVISORY PARAMETERS
User Manual
FLOREX
22
Parameter Description
Settings
(Default Value)
No
Yes
(Default : No)
No
Yes
(Default : No)
Supervisory permission for Alarm setpoint adjustments on
Operator Page. Set to ‘Yes’ for permission.
FLOW ALARM SP ADJUSTMENT ON OPERATOR PAGE
This parameter can be set as ‘Yes’ or ‘No’ to allow the user to
permit or restrict the adjustment of the ‘Total Alarm Setpoint’ on
Operator PAGE, respectively. If set to ‘Yes’, it allows adjustment,
else only view the set value.
TOTAL ALARM SP ADJUSTMENT ON OPERATOR PAGE
This parameter can be set as ‘Yes’ or ‘No’ to allow the user to
activate or de-activate the ‘Storage of Minimum & Maximum value
of Flow Rate’ feature, respectively. If set to ‘Yes’, it facilitates user
to View or Reset the stored Minimum & Maximum value of Flow
Rate on View Only Parameters.
STORAGE OF MIN./ MAX. FLOW RATE ACTIVATION
No
Yes
(Default : No)
Table 8.1
Section 8
To Next Page
Loading...
