5.23 Ellipitical Fitness Crosstrainer
Page 6
3. Watch the display as the LED test progresses. The test is programmed to display the
following LED illumination sequence:
a. The test name “DISPLAY” will be displayed for 2 seconds.
b. The left half of the L.E.D. matrix illuminates.
c. The right half of the L.E.D. matrix illuminates.
d. All remaining L.E.D.’s, including the heart rate and annunciator L.E.D.’s illuminate.
5. Press the ENTER key to proceed to the keyboard test.
6. The test name “KEYBOARD” will be displayed for 2 seconds.
7. A graphical representation of all the keys on the keyboard will be displayed. When a key is
pressed the representation of the key will be turned “off”. Check all of the keys on the
keyboard in this manner.
8. Press and hold the ENTER key for a minimum of 2 seconds to proceed to the heart rate test.
9. The test name “HEART RATE” will be displayed for 2 seconds.
10. A chest strap heart rate transmitter or a heart rate test transmitter must be used in
conjunction with this test. If no heart rate signal is being received, the message NO HR
RCVR will be displayed.
11. When a heart rate signal is being received, unfiltered (U ---) and filtered (F ---) heart rate
signals will be displayed. All of the Smart Rate L.E.D.’s will illuminate.
12. When a heart rate signal is received, the unfiltered and filtered heart rates will be displayed.
In addition the Polar heart rate will be displayed in the “Heart Rate” window and the
appropriate Smart Rate L.E.D. will flash.
13. Press the ENTER key to proceed to the brake test.
14. The test name “LIFT A/D” will be displayed for 2 seconds.
15. The incline percentage will be displayed on the left and the lift calibration number will be
displayed on the right. The lift calibration number indicates the physical position of the
incline and is used to calibrate the lift motor.
16. The test name “BRAKE” will be displayed for 2 seconds.
17. The resistance level will be displayed on the left side of the display and the corresponding
power bits (duty cycle) will be displayed on the right side of the display. Initially, the power
bits level will be zero, pressing the
, keys will change the number of power bits being
applied to the eddy current system.
18. Press the ENTER or RESET key to exit the diagnostics program.
To Next Page
Loading...
Need help?
General
