5.23 Elliptical Fitness Crosstrainer
Page 7
Procedure 2.2 - Accessing the Information Display
Procedure
1. Plug the power cord into the wall outlet, then turn on the EFX 5.23 with the on/off switch.
2. With the PRECOR EFX 5.23 banner displayed, press keys RESET,6,5, sequentially.
The EFX 5.23 Information display cycles through the following displays:
a. Odometer
b. Hour meter
c. Software version
d. Error log
5. The display name “ODOMETER” will be displayed for 2 seconds. Then the odometer value
will be displayed, as total strides accumulated.
6. Press the ENTER key to proceed to the hour meter display.
7. The display name “HOUR METER” will be displayed for 2 seconds. Then the hour meter
value will be displayed, as the total number of hours of use. Fractional parts of an hour are
stored internally, the display will be truncated to the nearest full hour.
8. Press the ENTER key to proceed to the software version display.
9. The display name “SW VERSION” will be displayed for 2 seconds.
10. The upper software version (UPPER X.XX) will be displayed. Pressing either SELECT key
will toggle between the upper and lower software version display.
11. Press the ENTER key to proceed to the error log display
12. The display name “ERROR LOG” will be displayed for 2 seconds.
13. The first error log entry will be displayed (1: ERXX).
14. Pressing the
, keys will move you through the log entries. Entry 1 will be the most recent
error log entry, with each succeeding entry being older than the preceding entry.
15. Pressing the SELECT key will toggle the display between the log entry (ERROR), the
odometer reading (STRIDES) when the error occurred and the hour meter (HOURS) when
the error occurred.
To Next Page
Loading...
Need help?
General
